Ny-Series Instructions Reference Manual (W560 - Omron NY532-5400 Reference Manual

LD
A
_CBU_No00
UINT#1
Array0
Array1
Array2
ST
ChangeIPAdr_instance(A,_CBU_No00,UINT#1,Array0,Array1,Array2,B,Busy0,Error0,ErrorID0);
The IP address that was obtained from the BOOTP server is set for the EtherNet/IP
Unit with a unit number of 00.
Then, each time the power supply is turned ON, the IP address is reset to the IP
address that is obtained from the BOOTP server.
IP address is changed to the value that was obtained from the BOOTP server.
Related System-defined Variables
Name
*1
_EIP_EtnOnlineSta
*2
_EIP1_EtnOnlineSta
*3
_EIP2_EtnOnlineSta
*4
_EIPIn1_EtnOnlineSta
*1 Use this variable name for an NJ-series CPU Unit.
*2 Use this variable name for port 1 on an NX-series CPU Unit, or for an NY-series Controller.
*3 Use this variable name for port 2 on an NX-series CPU Unit.
*4 Use this variable name for the internal communication port on an NY-series Controller.
Additional Information
• If you specify the built-in EtherNet/IP port with UnitNo, the following events are recorded in the event
log when the instruction is executed.
• Link OFF Detected
• IP Address Fixed
• If you specify the internal communication port with UnitNo, the following events are recorded in the
event log when the instruction is executed.
• IP Address Fixed
• You can change the IP address with this instruction even if the CPU Unit is write protected.

NY-series Instructions Reference Manual (W560)

ChangeIPAdr_instance
ChangeIPAdr
Execute Done
UnitNo Busy
BootPControl Error
IPAdr ErrorID
SubnetMask
DefaultGateway
EtherNet/IP Unit with unit number 00
Data
Meaning
type
Online BOOL
2 Instruction Descriptions
B
Busy0
Error0
ErrorID0
Description
This variable indicates when built-in EtherNet/IP
port communications can be used.
TRUE: Communications are possible.
FALSE: Communications are not possible.
2
2-1095