External Device I/Os; Overriding Outputs - Mitsubishi Electric MelcoREMOTE Installation And Operation Manual

Using the Up and Down buttons to the right of the LCD the other I/Os can be viewed (IN02, IN03, IN04 etc...).
When the connection type is GPRS or Ethernet, if the I/Os have not been pre-configured they will have their default I/O
name and unit of measure, and configurable inputs will have their default input type which is 0-10V..
When set to standalone I/O module mode (Connection Type set to None (slave)) the configurable input types must be
changed via the Configuration Screen. The configurable input values on the I/O Status screen will always be shown in
their raw units (i.e. Volts, mA or Ω).

12.7.1. External device I/Os

External device I/Os are only viewable on the screen if those external devices have been pre-configured.
If MelcoREMOTE fails to read a register from an external device its value will show READ ERROR, or if
MelcoREMOTE fails to write to a register value WRITE ERROR will be shown.

12.7.2. Overriding outputs

To aid commissioning, digital output type I/Os can be overridden (ON/OFF) to test installation wiring. To override a
digital output navigate to it by pressing the Up and Down buttons and press the Toggle button. The value shown on
screen will update to reflect the new value.
Page 34 of 52
I/O Status screen for digital output DO01