Advertisement
Step 13.
Place the rear leg assembly in the mating position
under the frame.
Note: Make sure the thread posts in the frame
and the holes in the rear leg assembly are in
alignment.
Step 15.
Secure the rear feet to the frame using (2) M10
Hex Head Screws with (2) M10 Split Lock Wash-
ers, and (2) M10 Flat Washer.
Torque screws to 35-40 lb-ft (47-54 Nm).
Note: Start threading screws by hand, then
tighten using an 18mm open-end or socket
wrench.
7
ASSEMBLY INSTRUCTIONS
Step 14.
Locate (2) M10 Hex Head screw. Pre-install an M10
Split Lock Washer and an M10 Flat Washer onto each
Hex head screw.
Note: Pay attention to the order of assembly of the
Split Lock Washer and Flat Washer.
Step 16.
Secure the front feet to the frame using (2) M10 Hex
Head Screws with (2) M10 Split Lock Washers, and
(2) M10 Flat Washer.
Torque screws to 35-40 lb-ft (47-54 Nm). Verify
that the front and rear feet are parallel to each
other.
Note: Start threading screws by hand, then tighten
using an 18mm open-end or socket end wrench.
620-8006 Rev A
Advertisement
