Cisco Catalyst 3750-E Software Configuration Manual page 119

Chapter 3 Assigning the Switch IP Address and Default Gateway
Table 3-4 Environment Variables (continued)
Variable
SWITCH_NUMBER
SWITCH_PRIORITY set SWITCH_PRIORITY
When the switch is connected to a PC through the Ethernet management port, you can download or
upload a configuration file to the boot loader by using TFTP. Make sure the environment variables in
Table 3-5
Table 3-5
Variable
MAC_ADDR
IP_ADDR
DEFAULT_ROUTER
OL-21521-01
Boot Loader Command
set SWITCH_NUMBER
stack-member-number
Changes the member number of a stack
member.
stack-member-number
Changes the priority value of a stack member.
are configured.
Environment Variables for TFTP
Description
Specifies the MAC address of the switch.
Note
However, if you modify this variable after the boot loader is up or the value
is different than the saved value, enter this command before using TFTP.
Specifies the IP address and the subnet mask for the associated IP subnet of
the switch.
Specifies the IP address and subnet mask of the default gateway.
Cisco IOS Global Configuration Command
switch current-stack-member-number renumber
new-stack-member-number
Changes the member number of a stack member.
Note
switch stack-member-number priority
priority-number
Changes the priority value of a stack member.
Note
We recommend that you do not modify this variable.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Modifying the Startup Configuration
This command is supported only on
Catalyst 3750-E switches.
This command is supported only on
Catalyst 3750-E switches.
3-23