Understanding Ipv6 - Cisco Catalyst 3750-E Software Configuration Manual

Configuring IPv6 Unicast Routing
This chapter describes how to configure IPv6 unicast routing on the Catalyst 3750-E or 3560-E switch.
For information about configuring IPv4 unicast routing, see
Routing."For information about configuring IPv6 Multicast Listener Discovery (MLD) snooping, see
Chapter 25, "Configuring IPv6 MLD Snooping."
lists (ACLs) see
To use all IPv6 features in this chapter, the switch or stack master must be running the IP services feature
Note
set. Switches running the IP base feature set support only IPv6 static routing and RIP for IPv6.
To enable IPv6 routing, you must you must configure the switch to use the a dual IPv4 and IPv6 switch
database management (SDM) template. See the
page
Unless otherwise noted, the term switch refers to a Catalyst 3750-E or 3560-E standalone switch and to
a Catalyst 3750-E switch stack.
Note For complete syntax and usage information for the commands used in this chapter, see the Cisco IOS
documentation referenced in the procedures
This chapter consists of these sections:
•
•
•

Understanding IPv6

IPv4 users can move to IPv6 and receive services such as end-to-end security, quality of service (QoS),
and globally unique addresses. The IPv6 address space reduces the need for private addresses and
Network Address Translation (NAT) processing by border routers at network edges.
For information about how Cisco Systems implements IPv6, go to this URL:
http://www.cisco.com/en/US/products/ps6553/products_ios_technology_home.html
OL-9775-08
Chapter 36, "Configuring IPv6 ACLs."
41-5.
"Understanding IPv6" section on page 41-1
"Configuring IPv6" section on page 41-10
"Displaying IPv6" section on page 41-27
C H A P T E R
Chapter 40, "Configuring IP Unicast
For information on configuring IPv6 access control
"Dual IPv4 and IPv6 Protocol Stacks" section on
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
41
41-1