Unsupported Wccp Features; Configuring Wccp; Default Wccp Configuration; Wccp Configuration Guidelines - Cisco Catalyst 3750-E Software Configuration Manual

Chapter 45 Configuring Cache Services By Using WCCP
•
•
Stack members receive the WCCP information from the master switch and program their hardware.

Unsupported WCCP Features

These WCCP features are not supported in this software release:
•
•
•
•

Configuring WCCP

These sections describe how to configure WCCP on your switch:
•
•
•

Default WCCP Configuration

Table 45-1
Feature
WCCP enable state
Protocol version
Redirecting traffic received on an interface

WCCP Configuration Guidelines

Before configuring WCCP on your switch, make sure to follow these configuration guidelines:
•
•
•
OL-9775-08
It distributes the WCCP information to any switch that joins the stack.
It programs its hardware with the WCCP information it processes.
Packet redirection on an outbound interface that is configured by using the ip wccp redirect out
interface configuration command. This command is not supported.
The GRE forwarding method for packet redirection is not supported.
The hash assignment method for load balancing is not supported.
There is no SNMP support for WCCP.
Default WCCP Configuration, page 45-5
WCCP Configuration Guidelines, page 45-5
Enabling the Cache Service, page 45-6
Default WCCP Configuration
The application engines and switches in the same service group must be in the same subnetwork
directly connected to the switch that has WCCP enabled.
Configure the switch interfaces that are connected to the clients, the application engines, and the
server as Layer 3 interfaces (routed ports and switch virtual interfaces [SVIs]). For WCCP packet
redirection to work, the servers, application engines, and clients must be on different subnets.
Use only nonreserved multicast addresses when configuring a single multicast address for each
application engine.
(required)
Default Setting
WCCP services are disabled.
WCCPv2.
Disabled.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
Configuring WCCP
45-5