Table of Contents
Advertisement
In the following cases, the rear height control suspension
will not operate.
D The underbody of the vehicle has touched the surface on
bumpy roads.
D The area around the rear suspension is coated with ice.
If the vehicle is moved to its usual location or the ice is removed
and the height select switch is pressed, the vehicle height
control cannot be operated. In this case, turn off and restart the
engine, then push the control switches.
(c) Vehicle height adjustment
"
1
Higher
2
Lower
To change the mode, push the height select switch on
either side of "Y" (higher) or "B" (lower).
STARTING AND DRIVING
The height control indicator light indicates which mode is
selected. (See "(e) Height control indicator light" described
below.)
D Selecting the "HI" mode
Push the height select switch on the "Y" side when the vehicle
speed is under about 30 km/h (19 mph).
To change the "N" mode to "HI": Push the switch once.
To change the "LO" mode to "HI": Push the switch twice. It
takes about 30 seconds until the "LO" mode changes to the "HI"
mode.
D Selecting the "N" mode
To change the "HI" mode to "N": Push the height select
switch on the "B" side once.
To change the "LO" mode to "N": Push the height select
switch on the "Y" side once.
D Selecting the "LO" mode
Push the height select switch on the "B" side while the vehicle
is stopped.
To change the "N" mode to "LO": Push the switch once.
To change the "HI" mode to "LO": Push the switch twice.
Even if the engine is stopped while the vehicle height is being
lowered, the operation continues for up to 25 seconds. If within
this 25 seconds, any of the side doors or the back door is
opened, operation will continue for a further 15 seconds.
397
Advertisement
Table of Contents
