Operational Instructions - Stamina 55-1631 Owner's Manual

OPERATIONAL INSTRUCTIONS

USING THE FITNESS METER
POWER ON :
Move the pedals or press the button.
POWER OFF :
Automatically shuts off after four minutes of
inactivity.
FUNCTION BUTTON:
Press to select lower display functions. Lower display functions including
SCAN, TIME, DISTANCE, CALORIES, ODOMETER, and RPM.
Press and hold for two seconds to reset all functions to zero, except
ODOMETER.
FUNCTIONS:
SPEED: Displays the current speed from zero to 999.9 miles per hour.
Automatically scans each function of TIME, DISTANCE, CALORIES, ODOMETER, and
SCAN:
RPM in sequence changing every six seconds. Press and release the button until the arrow
appears on the display and points to the SCAN.
TIME:
Displays the time from one second up to 99:59 minutes. After four seconds of inactivity, the
meter will automatically stop timing the workout. Restart the workout time by moving the
pedals.
DISTANCE:
Displays the distance from zero to 9999 miles.
CALORIES:
Displays the calories burned from zero to 999.9 Kcal.
The calorie readout is an estimate for an average user. It should be used only as a comparison
between workouts on this unit.
ODOMETER:
Displays the total accumulated distance you have traveled from zero to 9999 miles. The
total accumulated distance is retained when the meter is turned off.
RPM:
Displays crank RPM (revolutions per minute), from zero to 9999 rpm.
NOTE: 1. The meter will shut off automatically after four minutes of inactivity. All function values
will be kept. Press the button and hold it down for two seconds to reset all functions to
zero, except ODOMETER.
2. The ODOMETER will be reset to zero after batteries are removed for battery
replacement or storage of the unit.
HOW TO INSTALL AND REPLACE BATTERIES:
1. Find the two cavities on either side of the meter case, grasp the
METER (24) and pull it out from the casing being careful not to
disconnect or damage the SENSOR WIRE(30).
2. The meter operates with two AAA batteries, the batteries are not
included. Refer to the illustration to install or replace the batteries.
3. Push the METER (24) back into position.
NOTE:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline
battery with another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled
according to all state and federal laws and regulations.
5. Do not dispose of batteries in fire.
11
DIST CAL ODO RPM SCAN
AAA Batteries
TIME