Storage; Maintenance - Stamina 55-1631 Owner's Manual

STORAGE

1. To store the InMotion® Compact Strider Pro simply keep it in a clean dry place.
2. The minimum rest dimensions of the InMotion® Compact Strider Pro are approximately 25.5 inches
long x 16.7 inches wide x 43.7 inches tall. These dimensions may vary. Please measure your InMotion®
Compact Strider Pro if exact dimensions are needed.
3. Grasp the handle on the top of the product and the HANDLEBAR POST(59) to move the InMotion®
Compact Strider Pro. Do not use the PEDAL ARMS(51, 40) to move the InMotion® Compact Strider
Pro. The PEDAL ARMS (51, 40) will move and may pinch your hand or fingers.
4. To avoid damage to the electronics, remove the batteries from the METER(24) before storing the
InMotion® Compact Strider Pro for one year or more.

MAINTENANCE

The safety and integrity designed into the InMotion® Compact Strider Pro can only be maintained
when the InMotion® Compact Strider Pro is regularly examined for damage and wear. Special
attention should be given to the following:
1. Adjust the TENSION KNOB(13) and verify that it functions properly and the resistance changes.
2. Verify that the WARNING LABEL(70) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(70) if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components must be replaced immediately or the InMotion® Compact Strider
Pro removed from service until repair is made.
5. Only Stamina Products supplied components should be used to maintain/repair the InMotion®
Compact Strider Pro.
6. Keep your InMotion® Compact Strider Pro clean by wiping it off with an absorbent cloth after use.
NOTE: A standard crank extractor tool is required to remove the CRANKS(7) from the AXLE(75).
14