Configuring Bfd Over Bundle Per Member Mode - Cisco ASR 9000 Series Routing Configuration Manual

Implementing BFD

Configuring BFD over Bundle per Member Mode

To configure BFD over bundle per member link mode, complete the below steps:
This procedure is applicable for releases up to 5.3.0.
Note
SUMMARY STEPS
1. configure
2. bfd bundle per-member mode {cisco | ietf}
3. interface {bundle-ether | bundle-pos} bundle_ID
4. bfd address-family ipv4 fast-detect
5. bfd
6. bfd multiplier multiplier
7. bfd address-family ipv4 destination ip-address
8. bfd address-family ipv4 timers start seconds
9. bfd address-family ipv4 timers nbr-unconfig seconds
10. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
bfd bundle per-member mode {cisco | ietf}
Example:
RP/0/RSP0/CPU0:router(config)# bfd bundle
per-member mode ietf
Step 3 interface {bundle-ether | bundle-pos} bundle_ID
Example:
RP/0/RSP0/CPU0:router(config)# interface
bundle-either 1
Step 4 bfd address-family ipv4 fast-detect
Example:
RP/0/RSP0/CPU0:router(config)# bfd
address-family ipv4 fast-detect
minimum-interval milliseconds
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
Configuring BFD on Bundle Member Links
Purpose
Enables Cisco or IETF mode for BFD over per-bundle member
link. Default is cisco .
Enters interface configuration mode for the specified bundle
ID.
Enables IPv4 BFD sessions on bundle member links.
267