Cisco ASR 9000 Series Routing Configuration Manual page 179

Implementing BGP
SUMMARY STEPS
1. configure
2. router bgp as-number
3. vrf vrf-name
4. address-family { ipv4 | ipv6 } unicast
5. Do one of the following:
6. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 router bgp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 120
Step 3 vrf vrf-name
Example:
RP/0/RSP0/CPU0:router(config-bgp)# vrf vrf_a
Step 4 address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RSP0/CPU0:router(config-vrf)# address-family ipv4
unicast
• redistribute connected [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute eigrp process-id [ match { external | internal }] [ metric metric-value ] [
route-policy route-policy-name ]
• redistribute isis process-id [ level { 1 | 1-inter-area | 2 }] [ metric metric-value ] [ route-policy
route-policy-name ]
• redistribute ospf process-id [ match { external [ 1 | 2 ] | internal | nssa-external [ 1 | 2
]}] [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute ospfv3 process-id [ match { external [ 1 | 2 ] | internal | nssa-external [ 1 |
2 ]}] [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute rip [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute static [ metric metric-value ] [ route-policy route-policy-name ]
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
Configuring a VPN Routing and Forwarding Instance in BGP
Purpose
Specifies the autonomous system number and enters
the BGP configuration mode, allowing you to
configure the BGP routing process.
Enables BGP routing for a particular VRF on the PE
router.
Specifies either an IPv4 or IPv6 address family unicast
and enters address family configuration submode.
To see a list of all the possible keywords and
arguments for this command, use the CLI help (?).
149