Planet VC-1602 User Manual page 33

VLAN Port Configuration
When the VLAN-enabled switch receives an untagged packet, the packet will be sent to
the port's default VLAN according to the PVID (port VLAN ID) of the receiving port.
To change the PVID
Double click the "PVID" column of a port.
1.
2. Input a new VLAN ID (1~255).
Press "Enter" to submit the value.
3.
4. Click Apply button to apply it.
1. All the ports are default as members of VLAN 1 and assigned PVID 1.
2. Though you can configure a VLAN group with VLAN ID from 1 to 4094,
ë
Note
3. The port which was assigned a PVID and the PVID is equal to LAN ID,
4. Automatically, a port will join the VLAN of its PVID, and if the VLAN
To Enable/Disable Ingress Filtering
When one packet comes in from Port X to VLAN Y, but Port X is not a member of VLAN Y:
Ingress Filter Enabled - The filter checks the packet and detects Port X does not
Ingress Filter Disabled - All the packets destined to VLAN Y are all unobstructed.
Click the "Ingress Filtering" column of a port and select 'Enable' to activate Ingress Filter.
Port Group VLAN
The Port Group VLAN (Port-based VLAN) is concentrate on definite ports. The packets
forwarding policies are based on destination MAC addresses or related ports by voluntary
learning relationship of MAC addresses and its related ports.
- All Together
Click All Together button then all the ports of the switch will be added to VLAN
group 1.
- All Independent
the supported PVID on this switch is only from 1 to 255.
removing the port will not allow until you change it.
does not exist, system will create it.
belong to the VLAN Y, the Ingress Filter discards the
packet.
- 30 -