Table of Contents
Advertisement
2. Management
Setup
3. Device Control
2. System Information
3. System Configuration
1. Network Configuration
2. Console Port Status
Display
3. SNMP Community
Setup
4. Trap Receiver Control
5. Management Features
Control
6. Trap Filtering Setup
1. Port
Status/Configuration
2. Address Table
3. VLAN
4. Security
5. IGMP Snooping
6. Mirror
7. Statistic Information
- 13 -
Show detail system information of each
switch including their hardware, software
version, system up time, system contact,
device name, device location and system
management capabilities.
Modify system contact, device name and
device location of each switch on the
stack.
Configure each switch's IP address,
subnet mask and default gateway.
Display the console port configuration,
like baudrate, databits, parity, etc.
Create,
modify
or
community
name,
associated with the name and the access
right. Up to 5 entries are supported.
Create, modify or delete the community
name, IP address and aging time of the
trap receivers.
Up to 5 receivers are
supported.
Enable or disable web, telnet and SNMP
management function of the switch. You
can also change the http port number on
this menu.
Define which events will trigger the trap
on this menu.
Show the status of each VDSL and
Ethernet ports and configure each ports
settings. It also allows you to check the
status
of
connected
converter),
reset
the
loopback test.
Create, delete and display the MAC
address entries of each port. You can
also modify the aging time and search a
specified MAC address on this menu.
Two VLAN modes are supported on this
switch, 802.1Q VLAN and port group
VLAN.
Please select the VLAN mode
first and then make further configuration.
Please refer to section 4.9 for detail
configuration available on this switch.
This function is reserved for future use.
Enable or disable the IGMP Snooping.
You can also display the IP multicast
registration table on this menu.
Enable or disable the mirror function and
choose the sniffer port and monitored
port.
Show traffic information of each VDSL
and Ethernet ports.
delete
SNMP
the
IP
address
CPE
(VDSL
CPE
and
do
Advertisement
Table of Contents
