Connect 3Wxm Clients To 3Wxm Services; Configure 3Wxm Services - 3Com 3CRWX120695A User Manual

Connect 3WXM Clients to 3WXM Services

To connect the client to Services:
1 Select Start > Programs > 3Com > 3WXM > 3WXM. The 3WXM
Services Connection wizard is displayed.
2 Enter the IP address or fully-qualified hostname of the machine on which
the service is installed.
If 3WXM Services is installed on the same machine as the one you are
using to run 3WXM client, enter 127.0.0.1 as the IP address. This is a
standard IP loopback address.
3 Specify the service port, if different from the port number in the Service
Port listbox.
The port number used by the monitoring service must not be used by
another application on the machine where the monitoring service is
installed. If the port number is used by another application, change the
port number on the monitoring service. (See "Configure 3WXM Services"
below.)
4 Click Next to connect to the server.
5 If the Certificate Check dialog is displayed, click Accept.
If you left the Open Network Plan option on the 3WXM Services
Connection dialog selected, the server opens a new (blank) network plan.

Configure 3WXM Services

You can change the properties of 3WXM Services.
If a firewall is enabled on the host where you install 3WXM Services,
3WXM Services will not be able to communicate with 3WXM client or
with WX switches unless the firewall is configured to allow through
traffic for the SSL and SNMP ports (443 and 162 by default).
Installing 3WXM 19