What's Next - 3Com 3CRWX120695A User Manual

68 C 3: C
HAPTER ONFIGURING

What's Next?

W S
IRELESS ERVICES
4 Click Next. The VLAN Member Selection page is displayed.
5 From the Available Members pane, select the network ports that will be
used to reach the router interface and click Add.
If the network port is an 802.1Q tagged trunk link, select the Tag
checkbox for the port or port group. By default, the checkbox is not
selected.
To remove a tag for a port or port. Double-click the Tag Value column
for the port or port group. Change the tag value.
If you specify a tag value, 3Com recommends that you use the same
value as the VLAN number. 3Com wireless switches do not require the
VLAN number and tag value to be the same, but other devices may do so.
6 (Optional) If you want to add STP to a VLAN, select the Spanning Tree
tab and set options.
7 (Optional) For STP, select the Spanning Tree Port Setup tab and set
options.
After you create Employee services, you can create additional services.
For information about configuring additional services, refer to:
"Configure Guest Access Services" on page 69
"Configure Voice over Wireless IP Service" on page 77
After you have created additional services, you can create your RF
environment, and deploy your configuration and enable monitoring.
For information about creating your RF environment, refer to:
"Using RF Auto-Tuning" on page 91
"Using RF Auto-Tuning with Modelling" on page 99
"Using RF Planning" on page 113
For information about deploying your configuration and enabling
monitoring your network, refer to:
"Managing and Monitoring Your Network" on page 143.