Installing An Ac Power Supply Unit - Dell PowerEdge R530 Owner's Manual

Figure 64. Removing an AC PSU
1 release latch
3 PSU
5 PSU handle
Related link
Safety instructions
Before working inside your system
After working inside your system

Installing an AC power supply unit

Installing an AC power supply unit
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE: The maximum output power (shown in watts) is listed on the PSU label.
1 Follow the safety guidelines listed in the Safety instructions section.
2 For systems that support redundant power supply units (PSUs), ensure that both the PSUs are of the same type and have the same
maximum output power
3 If installed, remove the PSU blank.
Steps
1 Slide the new PSU into the chassis until the PSU is fully seated and the release latch snaps into place.
NOTE: If you unlatched the cable management arm, relatch it. For information about the cable management arm, see
the rack documentation of your system.
2 Connect the power cable to the PSU and plug the cable into a power outlet.
CAUTION: When connecting the power cable, secure the cable with the strap.
2 PSU cable connector
4 power connector
Installing and removing system components 131