Removing A Processor - Dell PowerEdge R530 Owner's Manual

Figure 56. Removing the heat sink
1 retention screw (4)
3 processor socket
Next steps
1 Remove the processor.
2 Install the heat sink.
3 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
Removing the cooling shroud
Removing the optional expansion card riser
Installing the optional expansion card riser
Installing the cooling shroud

Removing a processor

Installing a processor
Installing a heat sink
Removing a processor
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
NOTE: If you are upgrading your system, download the latest system BIOS version from Dell.com/support and follow the
instructions included in the compressed download file to install the update on your system.
120 Installing and removing system components
2 heat sink
4 heat sink retention socket (4)