Installing The Idrac Ports Card - Dell PowerEdge R530 Owner's Manual

Figure 47. Removing the iDRAC ports card
1 iDRAC ports card holder
3 SD vFlash media card reader
5 screws (2)
Next steps
1 Install the expansion card riser.
2 If applicable, connect the required power or data cables to the expansion card(s).
3 Install the cooling shroud.
4 If applicable, open the expansion card latch on the cooling shroud to support the full length expansion card.
5 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
Removing the cooling shroud
Removing the optional expansion card riser
Installing the optional expansion card riser
Installing the cooling shroud

Installing the iDRAC ports card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
2 iDRAC port
4 iDRAC ports card
6 iDRAC ports card connector on system board
Installing and removing system components 107