Connecting Power To The Enclosure; Connecting To The Device - Siemens RUGGEDCOM MX5000RE Installation Manual

Chapter 2
Installing the Device
Figure 22: Removing a Power Supply
1. Screws 2. Power Supply
3. Install the blank power module assembly into the empy slot to prevent the ingress of dust and dirt.
Section 2.2.2

Connecting Power to the Enclosure

To complete the power circuit, connect an external power supply to the PS1 and/or PS2 patch panels using male
Amphenol MIL-DTL 389999 size 13, code N connectors.
Figure 23: Power Supply Panel Connector
Section 2.3

Connecting to the Device

The following describes the various methods for accessing the ROX II console and Web interfaces on the device.
For more detailed instructions, refer to the ROX II User Guide for the RX5000.
26
2
1
3. Chassis
3
Pin
A
B
C
D
RUGGEDCOM MX5000RE
Installation Guide
Description
PS LIve/+
Spare
PS Neutral/-
Spare
Connecting Power to the Enclosure