Siemens RUGGEDCOM MX5000RE Installation Manual page 16

Chapter 2
Installing the Device
Figure 5: AC Terminal Block Wiring
1. Live Terminal
Figure 6: DC Terminal Block Wiring
1. Live Terminal
5. Connect the neutral (-/N) lug from the PS1 cable assembly to the neutral terminal on the PS1 terminal block.
IMPORTANT!
If the ground terminals are not connected to safety Earth, the chassis ground connection must
be connected. For more information, refer to
Connection".
6. Connect the ground (GND) lug from the PS1 cable assembly to the ground terminal on the PS1 terminal
block.
7. If necessary, repeat
10
2. Ground Terminal 3. Neutral Terminal
2. Ground Terminal 3. Neutral Terminal
Step 4 to Step 6 to connect the PS2 cable assembly.
1 2 3
1 2 3
+
Section 2.1.2, "Installing the Chassis Ground
Installing the Power Supply Patch Cables
RUGGEDCOM MX5000RE
Installation Guide