Table of Contents
Advertisement
Request For Additional Remote Controls
NOTE:
Only key fobs that are programmed to the ve-
hicle electronics can be used to start and oper-
ate the vehicle. Once a key fob is programmed
to a vehicle, it cannot be programmed to any
other vehicle.
WARNING!
• Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
• For vehicles equipped with Keyless Enter-
N-Go — Ignition, always remember to
place the ignition in the OFF mode.
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
14
NOTE:
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
an authorized dealer.
General Information
The following regulatory statement applies to all
radio frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user's authority to operate the
equipment.
IGNITION SWITCH
Keyless Push Button Ignition
This feature allows the driver to operate the
ignition with the push of a button as long as the
key fob is in the passenger compartment.
The Keyless Push Button Ignition has four op-
erating positions, three of which are labeled and
will illuminate when in position. The three po-
sitions are OFF, ACC, and ON/RUN. The fourth
position is START. During start, ON/RUN will
illuminate.
NOTE:
If the ignition switch does not change with the
push of a button, the key fob may have a low or
dead battery. In this situation, a back up
method can be used to operate the ignition
switch. Put the nose side (side opposite of the
emergency key) of the key fob against the EN-
GINE START/STOP button and push to operate
the ignition switch.
Advertisement
Chapters
Table of Contents
