Fuses; General Information; Underhood Fuses - Dodge Challenger 2018 User Manual

Hide thumbs Also See for Challenger 2018:
Table of Contents

Advertisement

Stop/Turn Lamp
Rear Side Marker
Backup Lamp
Center High-Mount Stop Lamp (CHMSL)
License
* The headlamps are a type of high-voltage
discharge tube. High voltage can remain in the
circuit even with the headlamp switch off and
the key removed. Because of this, you should
not attempt to service a headlamp bulb yourself.
If a headlamp bulb fails, take your vehicle to an
authorized dealer for service.

FUSES

WARNING!
• When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse.
Never replace a fuse with another fuse of
higher amp rating. Never replace a blown
fuse with metal wires or any other material.
WARNING!
Do not place a fuse inside a circuit breaker
cavity or vice versa. Failure to use proper
fuses may result in serious personal injury,
fire and/or property damage.
• Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
• If the replaced fuse blows again, contact
an authorized dealer.
• If a general protection fuse for safety sys-
tems (air bag system, braking system),
power unit systems (engine system, trans-
mission system) or steering system blows,
contact an authorized dealer.
Bulb Number
LED (Serviced At Authorized Dealer)
LED (Serviced At Authorized Dealer)
LED (Serviced At Authorized Dealer)
LED (Serviced At Authorized Dealer)
LED (Serviced At Authorized Dealer)

General Information

The fuses protect electrical systems against
excessive current.
When a device does not work, you must check
the fuse element inside the blade fuse for a
break/melt.
Also, please be aware that when using power
outlets for extended periods of time with the
engine off may result in vehicle battery dis-
charge.

Underhood Fuses

The Front Power Distribution Center is located
in the engine compartment. This module con-
tains fuses and relays. Fuse cavity location and
descriptions are printed on the inside of the
power distribution center cover.
135

Advertisement

Table of Contents
loading

Table of Contents