Ignition Switch; Keyless Push Button Ignition - Dodge JOURNEY 2019 User Manual

2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user's authority to operate the
equipment.

IGNITION SWITCH

Keyless Push Button Ignition

This feature allows the driver to operate the
ignition with the push of a button as long as the
key fob is in the passenger compartment.
The Keyless Push Button Ignition has four op-
erating positions, three of which are labeled and
will illuminate when in position. The three posi-
tions are OFF, ACC, and ON/RUN. The fourth
position is START. During start, ON/RUN will
illuminate.
NOTE:
If the ignition switch does not change with the
push of a button, the key fob may have a low or
dead battery. In this situation, a back up
method can be used to operate the ignition
switch. Put the nose side (side opposite of the
emergency key) of the key fob against the EN-
GINE START/STOP button and push to operate
the ignition switch.
START/STOP Ignition Button
The push button ignition can be placed in the
following modes:
OFF
• The engine is stopped.
• Some electrical devices (e.g. central locking,
alarm, etc.) are still available.
ACC
• Engine is not started.
• Some electrical devices are available.
ON/RUN
• Driving position.
• All the electrical devices are available.
START
• The engine will start.
WARNING!
• When exiting the vehicle, always remove
the key fob from the vehicle and lock your
vehicle.
• Never leave children alone in a vehicle, or
with access to an unlocked vehicle.
11