If enable ACL, and then only the effective IP in ACL can access the router.
Step1
If you want to enable ACL, please choose "Enable" and then press "Apply
Changes" to apply your setting.
Step2
Click the Enable checkbox.
Step3
Enter the host IP address that you want to permit and click "Add".
Step4
Press "take effect" to enable the configuration.
If you choose "Enable" in ACL Capability, please make sure that your
Note
host IP is in ACL before it takes effect. Or you will not manage the
device from your PC.
3.7 Diagnostic
Your router is capable of testing your network and DSL connection. The individual tests are
listed as Ping, ATM Loopback, ADSL and Diagnostic.
3.7.1 Ping
This page is used to send ICMP ECHO_REQUEST packets to network host. The
diagnostic result will then be displayed.
Host Address: Enter the IP address that you wish to test. And then click "Go!" button for
testing.
3.7.2 ATM Loopback
Connectivity verification is supported by the use of the OAM loopback capability for both VP
and VC connections. This page is used to perform the VCC loopback function to check the
connectivity of the VCC.
53