Requesting an Echo Profile
•
In PROGRAM mode, navigate to: Level Meter >
Diagnostics (3.) > Echo Profile (3.1.).
•
Press RIGHT arrow
confidence
•
Use UP
that feature becomes active.
•
To move a cross-hair, press RIGHT arrow
to decrease.
•
To Zoom into an area, position the intersection of the cross-hairs at the center of
that area, select Zoom, and press RIGHT arrow
out.
•
To update the profile, select Measure and press RIGHT arrow
•
To return to the previous menu, select Exit then press RIGHT arrow
Device Address
Master Reset
Note: See
The unique address of the device on the network (also called PROFIBUS address).
Values
a)
In PROGRAM mode, navigate to: Level Meter > Communication (5.) > Device
Address (5.1.).
b)
Press RIGHT arrow
c)
If required, key in a new value and press RIGHT arrow
displays the new value.
d)
Press Mode
7ML19985LT01
SITRANS LR560 (PROFIBUS PA) – OPERATING INSTRUCTIONS
to request a profile.
distance from Low Calibration Point to vertical cross-hair
algorithm: tF (trueFirst)
distance from flange face to target
echo
TVT
or DOWN arrow
to scroll to an icon. When an icon is highlighted
on page 55 to reset Device Address to 126.
0 - 126. Default: 126
twice to open parameter view and enable Edit mode.
to return to Measurement mode.
pan left/right - selected
pan up/down
zoom
measure
exit
to increase the value, LEFT arrow
. Press LEFT arrow
to accept it. The LCD
to Zoom
.
.
Page 37