System Readiness; Confirm Correct Device Driver - Emerson Rosemount 3051P Reference Manual

Configuration
May 2017
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Review the approvals
section of the Rosemount 3051P Reference Manual for any restrictions associated with a safe
installation.
Before connecting a Field Communicator in an explosive atmosphere, ensure the instruments in

the loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.
In an explosion-proof/flameproof installation, do not remove the transmitter covers when power

is applied to the unit.
Electrical shock can result in death or serious injury.
Avoid contact with the leads and terminals. High voltage that may be present on leads can cause
electrical shock.
Avoid contact with the leads and terminals.

Process leaks could result in death or serious injury.
Install and tighten all four flange bolts before applying pressure.

Do not attempt to loosen or remove flange bolts while the transmitter is in service.

Replacement equipment or spare parts not approved by Emerson
could reduce the pressure retaining capabilities of the transmitter and may render the
instrument dangerous.
Use only bolts supplied or sold by Emerson as spare parts.

Improper assembly of manifolds to traditional flange can damage sensor module.
For safe assembly of manifold to traditional flange, bolts must break back plane of flange web

(i.e. bolt hole) but must not contact sensor module housing.
2.2

System readiness

If using HART

systems prior to commissioning and installation. Not all systems are capable of communicating with
HART Revision 7 devices.
For instructions on how to change the HART revision of your transmitter, see

revision" on page
2.2.1

Confirm correct device driver

1. Verify the latest Device Driver (DD/DTM
communications.
2. Reference
3. Select desired product and download the DD.
a. Reference
4
®
based control or asset management systems, confirm the HART capability of such
54.
Emerson.com or FieldCommGroup.org
Table 2-1 for the correct DD.
™
) is loaded on your systems to ensure proper
for the latest DD.
Reference Manual
00809-0700-4001, Rev AA
™
for use as spare parts
"Switching HART
Configuration