Tunturi Pure U bike 4.1 User Manual page 6

Assembly step B
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step C
• Connect the wires from upright tube
and main frame before sliding the
upright tube in position.
Remark:
Do not remove screws from the frame
before siding the upright tube in position.
• Use the enclosed Allen key to tighten
both fastening screws through the
holes in the tube from inside out.
• Tighten the fastening screws by
turning them counter-clockwise.
Remark:
First tighten all 6 bolts hand tight before
tightening them fully. This to avoid miss
alignment
6
Assembly step D
• Lead the wires for hand pulse
reading through the hole towards the
display assembly opening.
Remark:
Avoid the wires to damage during
assembly..
• Fit the handlebar to the upright tube
by using the shown hardware..
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step E
• remove the 4 assembly screws from
the consoles rear cover.
• Fix the console to the console
bracket.
• Guide the hand pulse wires coming
from the handlebar and data cable
coming form upright tube through the
console bracket hole.
• Connect the hand pulse wires and
data cable with the console.
• Fix the console bracket to the upright
tube.
Remark:
Avoid the wires to damage during
assembly