Frequency/Current Meter Calibration; Overtorque Detection Function - Omron SYSDRIVE 3G3SV-B2002-E User Manual

2-10-15 Multifunction Output Function
Item name
Multifunction output function
Set value
0 (see note) In operation
1 (see note) Frequency agreed
2 Zero speed
Frequency detection (output frequency ≥ frequency detection level)
3
4 Overtorque detected

2-10-16 Frequency/Current Meter Calibration

Item name
Analog output gain
analog output selection

2-10-17 Overtorque Detection Function

Item name
Overtorque detection level
Overtorque detection time
Overtorque detection signal
Overtorque detection selection
Terminal function at 3-WIRE sequence selection
3G3SV
Run command
1
(run at "closed")
Stop command
2
(stop at "open")
7
FWD/REV run
selection
9
(FWD run at "open",
REV run at "closed")
Constant to be set
No. 34 and No. 35
Functions of external output terminals 14 to 16, and 15 and 16 can
be switched.
Function of terminal 14 to 16: set into No. 34.
Function of terminal 15 and 16: set into No. 35.
Constant to be set
No. 45
No. 21
Frequency/current meter connected to the inverter can be cali-
brated without using a resistor for calibration.
Frequency/current meter
--
+ (3 V 1 mA full scale)
18
bn-11 FM
19
No. 21 = xx0x
0: Output frequency meter
1: Output current meter
Constant to be set
No. 38
No. 39
No. 34 and No. 35
No. 37
Refer to page 41.
Function
1.00
0000
160%
0.1 s
Refer to page 41.
Refer to page 42.
Section 2-10
Factory preset
Factory preset
Factory preset