Error Codes; Error Code Details - Canon LBP6670dn Series Service Manual

5
Trouble Shooting > Error Codes > Error Code Details

Error Codes

Error Code Details

E Detail Item
Code Code
E000 0000 Title Error in temperature rising of Fixing Assembly
Detection description Temperature of the Fixing Assembly did not reach a certain
temperature within the specified period of time.
Remedy 1. Check the connection of connectors between the Fixing
Assembly and the Engine Controller PCB.
2. If the connector at the Fixing Assembly side does not have
induction while the assembly is removed, replace the assembly.
3. Replace the Engine Controller PCB.
E001 0000 Title Abnormal high temperature of Fixing Assembly
Detection description It was detected that the temperature of the Fixing Assembly was
abnormally high.
Remedy 1. Check the connection of connectors between the Fixing
Assembly and the Engine Controller PCB.
2. If the connector at the Fixing Assembly side does not have
induction while the assembly is removed, replace the assembly.
3. Replace the Engine Controller PCB.
E003 0000 Title Abnormal low temperature of Fixing Assembly
Detection description After Heater turns on, Main Thermistor
detected a temperature of 120 deg C or lower for more than 20
seconds.
Remedy 1. Check the connection of connectors between the Fixing
Assembly and the Engine Controller PCB.
2. If the connector at the Fixing Assembly side does not have
induction while the assembly is removed, replace the assembly.
3. Replace the Engine Controller PCB.
E004 0000 Title Error in fixing power supply drive circuit
Detection description Error in either the Fixing Heater or the Main Motor
Remedy 1. Check the connection of connectors between the Fixing
Assembly and the Engine Controller PCB.
2. If the connector at the Fixing Assembly side does not have
induction while the assembly is removed, replace the assembly.
3. Reconnect the connector on the Main Motor.
4. Replace the Main Motor.
5. Replace the Engine Controller PCB.
E014 0000 Title Main motor error
Detection description Main motor failure is detected.
Remedy 1. Reconnect the connector on the Main Motor.
2. Replace the Main Motor.
5 Trouble Shooting > Error Codes > Error Code Details
Description
E Detail Item
Code Code
E06F 0068 Title EEPROM communication error
Detection description EEPROM communication error
Remedy 1. Reconnect the connector on the Engine Contoroller PCB.
2. Replace the Engine Contoroller PCB.
E100 0000 Title Laser Scanner error
Detection description Error is detected in the Laser Scanner or the Scanner Motor.
Remedy 1. Reconnect the connector on Laser Scanner Unit.
2. Replace the Laser Scanner Unit.
E245 2012 Title System error
Detection description System error
Remedy Contact the service company office
E245 2022 Title System error
Detection description System error
Remedy Contact the service company office
E247 0002 Title System error
Detection description System error
Remedy Contact the service company office
E247 0003 Title System error
Detection description System error
Remedy Contact the service company office
E247 0004 Title System error
Detection description System error
Remedy Contact the service company office
E602 0002 Title Firmware error
Detection description Bootable load failure
Remedy 1. Install the set of the controller firmware.
2. Replace the Main Controller PCB.
E602 0008 Title Memory area in the flash is depleted.
Detection description Remaining memory area in the flash is small.
Remedy * Turning OFF and then ON the main power stops the error code
to be displayed, but the continuous use causes the memory area
in the flash to be completely lost or causes symptoms as such
as machine freeze.
1. Turning OFF and then ON the main power stops the error
code to be displayed.
2. Export user information.
3. Replace the Main Controller PCB.
4. Import user information.
5-4
Description
5-4