Initializing E-Rds Settings - Canon LBP6670dn Series Service Manual

2
Technology > Embedded RDS > E-RDS Setup > Initializing E-RDS settings
If the communication is successful, "Done." is displayed. If "Could not execute." (failed)
appears, refer to the "Troubleshooting" and repeat until "Done." is displayed.
Done.
NOTE:
The communication results with UGW can be distinguished by referring to the
communication log. By performing the communication test with UGW, E-RDS acquires
schedule information and starts monitoring and meter reads operation.

■ Initializing E-RDS settings

It is possible to return E-RDS Settings to factory-shipments value.
● Setting values and data to be initialized
The following E-RDS settings, internal data, and Alarm filtering information are initialized.
• E-RDS > E-RDS SWITCH
• E-RDS > RGW-ADDRESS
• E-RDS > RGW-PORT
• E-RDS > COM-LOG
CAUTION:
In case of replacing the CA certificate file, even if initialization of E-RDS is executed, the
status is not returned to the factory default.
When installing the certificate file other than the factory default CA certificate file, it is
required to delete the certificate file after E-RDS initialization and install the factory
default CA certificate file.
For detailed procedures, see "Steps to E-RDS settings - step 5.".
2 Technology > Embedded RDS > E-RDS Setup > Initializing E-RDS settings
F-2-136
● Initialization procedure
1. Start [Service Mode].
2. Select [NETWORK GR.] and press [OK] or [
SERVICE MODE
LOG GR.
PANEL LOCK GR.
F/W UPDATE GR.
NETWORK GR.
3. Select [E-RDS] and press [OK] or [ ] button to go to E-RDS setting menu.
NETWORK GR.
FTP SYSLOG
JOB SERIALIZE
BUFFER LIMIT
E-RDS
4. Select [CLEAR] and press [OK] or [ ] button to display Confirm Initialization screen.
Select [Yes] and press [OK] button.
E-RDS Excute?
RGW-PORT No
COM-TEST Yes
COM-LOG
CLEAR
Initializing...
2-65
] button to go to the network setting menu.
F-2-137
F-2-138
Done.
F-2-139
2-65