Planar Dome C3i/EX User Manual page 41

Dome E2 Specification
In locations where 240V outlets are used, connect the Dome E2 display to only a center-
tapped, 240V, single-phase supply (only for Canada and the United States).
Category
Screen
Interface
Input formats
Physical
Power
Characteristic Item
Screen size diagonal
Resolution
Pixel pitch
Pixel arrangement
Active area (mm)
Grayscale supported
Refresh rate
Contrast ratio
Brightness
Pixel rise/fall time
Viewing angle
Digital Video In
Display control - brightness
Display identification
USB hub
Display status
Landscape orientation
Portrait orientation
Screen type
Display size (without stand)
Display weight (without stand)
Mounting options
Adapter
Specification
498 mm (19.6 in.)
1200 x 1600 pixels (portrait)
1600 x 1200 pixels (landscape)
0.249 mm x 0.249 mm
Subpixel vertical stripe
398.4 (H) x 298.8 (V)
3061 shades of gray
60 Hz
600:1 (typical)
2
900 cd/m (when new)
40 ms (typical)
170° (± 85°) horizontal/vertical
DVI Rev. 1.0 single-channel digital connector
DDC2B+
EDID read using DDC2B+
Universal Serial Bus (USB) Rev. 1.1:
1 uplink B port; 2 downlink A ports
Dual-stack tricolor LEDs on back panel
1600 x 1200 (8-bit per pixel)
1200 x 1600 (8-bit per pixel)
AMLCD (active matrix liquid crystal display)
440 mm x 343 mm x 95 mm
(17.3 in. x 13.5 in. x 3.75 in.)
5.5 kg (12 lb)
Desktop stand (standard);
100-mm VESA mounting (optional)
Ault MW116KA1249F53 (CAUTION: Use only the
power adapter supplied with the display unit.)
Dome E2 Specification | 31