Planar Dome C3i/EX User Manual page 39

Dome C3i Specification
In locations where 240V outlets are used, connect the Dome C3i display to only a center-
tapped, 240V, single-phase supply (only for Canada and the United States).
Category Characteristic Item
Screen Screen size diagonal
Resolution
Pixel pitch
Pixel arrangement
Active area (mm)
Grayscale supported
Refresh rate
Contrast ratio
Brightness
Pixel rise/fall time
Viewing angle
Interface Digital Video In
Display control - brightness
Display identification
USB hub
Display status
Input formats Landscape orientation
Portrait orientation
Screen type
Physical Display size (without stand)
Display weight (without stand)
Mounting options
Power Adapter
Specification
528 mm (20.8 in.)
1536 x 2048 pixels (portrait)
2048 x 1536 pixels (landscape)
0.207 x 0.207 mm
Subpixel vertical stripe
423.9 (H) x 318.0 (V)
3061 shades of gray – programmable gamma
60 Hz
600:1 (typical)
200 fL (typical); 700 cd/m
50 ms
160° (± 85°) horizontal/vertical
1 DVI single-channel digital connector
DDC2B+
EDID read using DDC2B+
Universal Serial Bus (USB) Rev. 1.1:
1 uplink B port; 2 downlink A ports
Dual-stack tricolor LEDs on back panel
2048 x 1536 (8-bit per pixel)
1536 x 2048 (8-bit per pixel), automatic hardware rotate
by DX2 board
AMLCD (active-matrix liquid crystal display)
485.9 mm x 381.0 mm x 101.6 mm
(19.1 in. x 15.0 in. x 4.0 in.)
6.35 kg (<15 lb)
Desktop stand with integrated USB (standard);
100-mm VESA mounting (optional)
Ault MW122KA1223F52 (CAUTION: Use only the power
adapter supplied with the display unit.)
2
(when new)
Dome C3i Specification | 29