Toshiba MMD-AP0186HP-E Service Manual page 94

No. Part name
Drain pump 1. Detachment
⑤
Float switch 1) Perform works until opening of the electric parts box
cover in works of 1 of ②.
2) Remove the connectors which connect to float switch
of the drain pump from the control P.C. board.
CN34 : Float switch (3P, Red)
CN504 : Drain pump (2P, White)
3) Loosen the fixing screws (2 positions) of the check cover
and then take out the check cover.
(To the check cover, the drain pump and float switch are
attached.)
4) Pick up the hose band, shift from the pump connecting
part, remove the drain hose and then remove the check
cover.
5) Remove screws which fix the drain pump assembly and
then remove the drain pump assembly. (Ø4 x 10, 3 pcs.)
6) Remove the resin nut switch and then remove the float
switch from the fixing plate.
2. Attachment
1) Using the removed screws, fix the drain pump assembly
as original.
2) Using the removed resin nut, fix the float switch as
original.
3) Connect the drain hose as original and then attach the
hose band.
NOTE
Insert the drain hose to the end of the drain pump.
4) Connect the drain pump and the float switch wiring as
original and close the electric parts box cover for fixing.
Be sure to perform wiring in the electric parts box as
original.
5) Enter the corners (2 positions) of the check cover in the
entering part and then fix it using fixing screws
(2 positions).
PMV motor 1. Detachment
⑥
1) Perform works until opening of the electric parts box
cover in works of 1 of ②.
2) Perform works until opening of the check cover in
works of 1 of ⑤.
3) Remove relay connector of the PMV motor.
4) As shown in the right figure, using a double spanner,
open the check port at the side face and then remove
the PMV motor.
2. Attachment
1) Connect the relay connector of the PMV motor as
original and close the electric parts box cover for fixing.
Be sure to perform wiring in the electric parts box as
original.
2) Enter the corners (2 positions) of the check cover in the
entering part and then fix it using fixing screws
(2 positions).
AMP Air Conditioning
Procedure
– 94 –
Remarks
Connector
position
CN34
CN504
Entering part
Fixing screws
Check cover
Drain pump
Hose band
Float switch
Screw
Resin nut
Relay connector of PMV motor
www.ampair.co.uk | sales@ampair.co.uk
Drain hose
Drain hose