Toshiba MMD-AP0186HP-E Service Manual page 41

Manual address setting using the remote controller
Procedure when setting indoor units' addresses first under the condition that indoor wiring has been completed
and outdoor wiring has not been started (manual setting using the remote controller)
Wiring example of 2 refrigerant lines
Refrigerant line 1
Remote
controller
Line (system) address
Indoor unit address
Group address
In the example above, disconnect the remote controller connections between the indoor units
and connect a wired remote controller to the target unit directly before address setting.
Pair the indoor unit to set and the remote controller one-to-one.
Turn on the power.
1
Push and hold the
LCD starts flashing.
AMP Air Conditioning
Outdoor
unit
Indoor unit 1 Indoor unit 2
1 1
1 2
1 2
Header unit Follower unit
SET DATA
TEMP.
2, 5, 8
11
FILTER
RESET TEST
1
CL
SET
, and buttons at the same time for more than 4 seconds.
Refrigerant line 2
Outdoor
unit
Indoor unit 3 Indoor unit 1
1 2
3 1
2 2
Follower unit Follower unit
Code No.
ON / OFF
3, 6, 9
TIMER SET FAN MODE
TIME SAVE VENT
4, 7, 1 0
SET CL SWING/FIX UNIT LOUVER
– 41 –
www.ampair.co.uk | sales@ampair.co.uk
Indoor unit 2
2
2
2
Follower unit