Toshiba MMD-AP0186HP-E Service Manual page 46

Changing the indoor unit address using a remote controller
To change an indoor unit address using a wired remote controller.
The method to change the address of an individual indoor unit (the indoor unit is paired
with a wired remote controller one-to-one), or an indoor unit in a group.
(The method is available when the addresses have already been set automatically.)
(Execute it while the units are stopped.)
1
Push and hold the
(If 2 or more indoor units are controlled in a group, the first indicated UNIT No. is that of the head unit.)
2 UNIT LOUVER
Push the
to change if 2 or more units are controlled in a group. (The fan and louvers of the selected
indoor unit are activated.)
(The fan of the selected indoor unit is turned on.)
3
Push the TEMP.
4
Push the TIME
section to that you want.
SET
5
Push the button.
UNIT LOUVER
6
Push the
to change.
Repeat steps to
4
UNIT LOUVER
7
Push the
8
If the addresses have been changed correctly, push the
AMP Air Conditioning
TEMP.
3
TIMER SET
8
FILTER
RESET TEST SET
1
CL
SET
, , and buttons at the same time for more than 4 seconds.
button (left side of the button) repeatedly to select an indoor unit number
/ buttons repeatedly to select
/ buttons repeatedly to change the value indicated in the SET DATA
button (left side of the button) repeatedly to select another indoor UNIT No.
to change the indoor unit addresses so as to make each of them unique.
6
button (left side of the button) to check the changed addresses.
ON / OFF
FAN MODE
TIME SAVE VENT
CL SWING/FIX UNIT LOUVER
2, 6, 7
13 13 13 13 13
for CODE No.
– 46 –
www.ampair.co.uk | sales@ampair.co.uk
4
5
button to finish the procedure.