Setting Number of Points (NOP)
The number of points (NOP) per sweep is set by following the procedure below.
Procedure
Step 1. Right-click to open the shortcut menu and click
Step 2. Using the numeric entry dialog box that appears by right-clicking inside the
Points
number of points.
NOTE
Number of points can be set as an integer from 2 to 801.
Number of points is set by the segment sweep table when the sweep type is segment
(segment sweep). For setting the segment sweep table, see "Sweeping a Plural Number of
Sweep Areas under Different Conditions at One Time (Segment Sweep)" on page 66.
Chapter 3
box (or using the ENTRY/NAVIGATION block keys on the front panel), enter the
Setting Measurement Conditions
Setting Number of Points (NOP)
(or press
Sweep Setup
Number Of
).
57