Using Time as Sweep Parameter (Zero Span Sweep)
Measurement using time as the sweep parameter can be executed by setting the sweep
parameter to zero. This sweep is called Zero Span sweep.
Procedure
Step 1. Set the sweep span to zero:
a. Right-click to open the shortcut menu and click
b. Using the numeric entry dialog box by right-clicking inside the
ENTRY/NAVIGATION block keys on the front panel), enter zero as the sweep span
value.
Step 2. Set sweep time:
a. Right-click to open the shortcut menu, and click
b. Click the
c. Using the numeric entry dialog box by right-clicking inside the
using the ENTRY/NAVIGATION block keys on the front panel), enter the sweep time
(i.e., sweep span in the time sweep).
NOTE
If the number of measurement points is set to the maximum value (801), the sweep time
can be set up to 16,080 second (approximately 4.5 hours).
Chapter 3
Using Time as Sweep Parameter (Zero Span Sweep)
button.
Sweep Time
Setting Measurement Conditions
(or press
Start/Stop
box (or using the
Span
(or press
Sweep Setup
Sweep Time
).
).
box (or
47