Basic Operations for RF Devices Measurement
STEP 2. Setting Measurement Conditions
Step 9. Select
Step 10. Specify Trace 3 as the active trace (* mark) as shown in Figure 3-9 and Figure 3-10.
Step 11. Select
Step 12.
Format
Setting the Measurement Points, Sweep Parameter, and Sweep Type
Step 1. Click
Step 2.
Number Of Points
Step 3.
Sweep Parameter
Step 4.
Sweep Type
Setting the Source Mode and Oscillator Level
Perform this setup in the same way as "Setting the Source Mode and Oscillator Level" on
page 49.
Setting the Sweep Range (Frequency)
Step 1. Click
Step 2. Select
Step 3. Select
Figure 3-20
Steps 2, 3
NOTE
When entering the frequency unit with the keyboard, type
54
in the
Log Y-Axis
Format
in the
X
Meas Parameter
box is set to
Lin Y-Axis
on the
Sweep Setup...
Stimulus
box is set to
box is set to
Frequency
box is set to
Linear
on the
Start/Stop...
Stimulus
box, and type
Start
[1] [.] [5] [G] [Enter]
box, and type
Stop
[2] [.] [5] [G] [Enter]
box (Figure 3-11).
box as shown in Figure 3-12.
in the initial state.
menu (Figure 3-13).
in the initial state (Figure 3-14).
201
in the initial state (Figure 3-14).
in the initial state.
menu (Figure 3-18).
on the keyboard (Figure 3-20).
on the keyboard (Figure 3-20).
for MHz and
for GHz.
[M]
[G]
Chapter 3