Setting the measurement point number, measurement parameter, and
BIN range setting mode for Condition 1
Step 1. Press the
display the BIN sorting setup display (Figure 8-17).
Figure 8-17
BIN sorting setup display
Step 2. Use the following procedure to set the measurement point number for Condition 1.
a. Click with the mouse the measurement point number (Stimulus) cell in the Condition 1
column to select the cell.
b. Click the down-arrow that appears in the right side of the cell.
c. In the drop-down list box that appears, click "(3) 100.00 MHz" (Figure 8-18).
Chapter 8
key in the instrument state block (INSTR STATE) on the front panel to
[Cmptr]
Sorting According to Measurement Results
Example of Settings for BIN Sorting
193