Cisco IR829 Hardware Installation Manual page 37

Product Overview
SFP Modules
Table 19 Maximum Operating Temperature
Type of SFP Module
Rugged and Industrial SFPs
–40 to 185°F (–40 to 85°C)
Commercial SFPs
32° to 158°F (0° to 70°C)
Extended Temperature SFP
23° to 185°F (-5° to 85°C)
Copper SFP
Supported on IOS 15.6(3)M but GE
only
NOTE: The WAN port GE0 can accept either fiber SFP or Copper SFP modules. The speed is fixed at 100Mbps or 1Gbps depending
on the SFP installed. Since there is no I-temp copper SFP available in the market, there is no Copper SFP supported. In order to use a
Copper SFP, you must enter service internal mode, and enter "unsupported transceivers". Then unplug and insert the Copper SFP again.
NOTE: Speed and duplex commands are not available on the GE0 WAN interface.
The following two Copper SFPs (non I-temp) will be officially supported at 1Gbps:
 Copper SFP - GLC- T
— Copper 1Gbps, (0 to 70°C), CPN is 30-1410-04
Model
GLC-SX-MM-RGD with digital optical monitoring
(DOM) support
GLC-LX-SM-RGD with digital optical monitoring
(DOM) support
GLC-ZX-SM-RGD with digital optical monitoring
(DOM) support
GLC-SX-MM
GLC-LH-SM
GLC-BX-U, with Digital Optical Monitoring (DOM) support
GLC-BX-D, with Digital Optical Monitoring (DOM) support
CWDM-SFP, with Digital Optical Monitoring (DOM) support
DWDM-SFP, with Digital Optical Monitoring (DOM) support
SFP-GE-S, with Digital Optical Monitoring (DOM) support
SFP-GE-L, with Digital Optical Monitoring (DOM) support
SFP-GE-Z, with Digital Optical Monitoring (DOM) support
GLC-SX-SMD
GLC-LH-SMD
GLC-EX-SMD
GLC-TE
GLC-FE-100LX-RGD
GLC-FE-100FX-RGD
GLC- T (0 to 70°C)
SFP-GE-T (-5 to 85°C)
35