Cisco IR829 Hardware Installation Manual page 11

Preface
Safety Warnings
WARNING: When installing the product, please use the provided or designated connection cables/power cables/AC adapters. Using any
other cables/adapters could cause a malfunction or a fire. Electrical Appliance and Material Safety Law prohibits the use of UL-certified
cables (that have the "UL" shown on the code) for any other electrical devices than products designated by CISCO. The use of cables that
are certified by Electrical Appliance and Material Safety Law (that have "PSE" shown on the code) is not limited to CISCO-designated
products. Statement 371
WARNING: Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow
the correct procedures could result in a hazardous situation to people and damage to the system. Statement 378
WARNING: To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits.
LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution
when connecting cables. Statement 1021
WARNING: This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably
installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable
grounding is available. Statement 1024
WARNING: If the symbol of suitability with an overlaid cross appears above a port, you must not connect the port to a public network that
follows the European Union standards. Connecting the port to this type of public network can cause severe personal injury or can damage
the unit. Statement 1031
WARNING: Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV) requirements in IEC 60950
based safety standards. Statement 1033
Requirements in IEC 60950 based safety standards. Statement 1033
WARNING: When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046
9