Before You Start; Checking What's In The Box; Using This Manual; Removing The Transport Stopper - Pioneer X-MT2000 Operating Instructions Manual

1 Before You Start

1
2
3
6
En

Checking what's in the box

Thank you for buying this Pioneer product. Before starting to set up your new stereo
system, please check that you have received the following supplied accessories:
• Two 'AAA' size R03 batteries
• Remote control unit
• Warranty card
• These operating instructions

Using this manual

This manual is for the X-MT2000. It is split into three sections: setting up (chapters 1 and
2); using the system (chapters 3 to 6), and additional information (chapter 7). This last
chapter contains care information for the unit and discs, a troubleshooting section and
specifications.

Removing the transport stopper

The transport stopper secures the disc tray for safe transportation. Be sure to remove it
before switching the unit on. Keep the stopper in case you need to transport the unit in the
future — see Moving the unit on page 29.
1 Remove the tape covering the transport stopper on the front of
the disc tray.
2 Pull out the transport stopper.

Putting the batteries in the remote

1 Turn over the remote control, then press and slide the battery
compartment cover off.
+
–
2 Put in the batteries supplied.
+ –
Take care to match the plus and minus ends of each battery with the markings inside the
compartment.
3 Slide the cover back on, and your remote is ready for use.
+
–
Tape Stopper
• FM wire antenna
• AM loop antenna
• Two Speaker Cords