Getting Started; Setting The Clock; Switching On The Clock In Standby - Pioneer X-MT2000 Operating Instructions Manual

TUNING
STANDBY
) !
1
$
&
)
2
STANDBY/ON
BASS/TREBLE
#*
)
3
CD SELECT OPEN/CLOSE
FUNCTION VOLUME
DISPLAY/
CLOCK
TIMER
ENTER (DEMO)
DISPLAY/ ENTER
CLOCK
DISPLAY
/CLOCK
POWER
4 ¢
ENTER
REMOTE CONTROL UNIT

Setting the clock

This system has a built in clock, which needs to be set to be able to use the timer features.
⁄
›
Note: If there is a power failure or the system is unplugged from the wall outlet, the
display shows AM 12:00 once power is restored until you set the clock again.
1 Switch on.
You can use the
the remote control.
2 Press and hold the DISPLAY/CLOCK button until the display
shows TIME?.
3 Press ENTER.
The display shows AM 12:00, with the hour blinking.
Use the 4 and ¢ buttons to set the hour, then press ENTER.
4
Use the 4 and ¢ buttons to set the minute, then press ENTER.
5

Switching on the clock in standby

If you want to display the time when the system is in standby, the clock can be set to
appear in your display. However, to consume less power, you can leave the clock off (this is
the default setting).
1 Switch on.
You can use the
the remote control.
2 Press and hold DISPLAY/CLOCK until the display shows TIME?.
Use the 4 or ¢ button to select TIME ON or TIME OFF.
3
Set to
TIME ON
This may be convenient, but the standby power consumption is higher.
Set to
TIME OFF
consumption is lower on this setting.
4 Press ENTER.
Tip
If you have chosen the
standby by press
When set to
TIME ON
you press
STANDBY
of the clock being displayed, the system remains in standby, but the clock display
disappears.
/ button on the top panel, or the
STANDBY ON
/ button on the top panel, or the
STANDBY ON
if you want to be able to display the time when the system is in standby.
if you don't need the clock display in standby. Standby power
setting, you can still display the clock for 4 seconds in
TIME OFF
/ .
DISPLAY CLOCK
, the clock is displayed after switching the system into standby. If
/ (top panel) /
ON POWER

4 Getting Started

button on
POWER
button on
POWER
(remote) again within 2 seconds
15
En