Ericsson R380E User Manual page 194

194 R380 Communications Suite
Note: Usually, it does not matter which serial port you use to connect
to your R380e. R380 Communications Suite quickly checks each port
in turn to find a connected R380e. If connection problems arise, see
"Troubleshooting" on page 201.
Plug the 9-pin connector on the cable into your computer serial
2.
port, and the Ericsson connector, with the logo facing upwards,
into the interface at the bottom of your R380e.
Note: You should not have to apply force when inserting the
connector into the port on your R380e. If you have difficulty
connecting the cable to your R380s, you may be attempting to insert
the connector upside down.
Your computer now attempts to establish contact with your
3.
R380e.
Note: The Ericsson RS232 cable supports the following five signals
in the RS232 standard: Tx, Rx, CTS, RTS, GND. If you experience
any problem with your connection, please go to Ericsson Mobile
Internet at: http://mobileinternet.ericsson.com for further
information and support.
Connecting with R380 Communications Suite
R380 Communications Suite automatically establishes a connection
between your computer and R380e. You can tell if your R380e is
connected by glancing at the Connection icon on the taskbar (close
to the clock).
Your computer is connected to the R380e. When a connection
•
is made, the icon appears as a telephone on the taskbar (close to
the clock).
Connecting for the first time
When you connect to your computer for the first time, a connection
wizard tries to identify your R380e.
Follow the instructions in the wizard.
1.
Enter a name to identify your R380e when asked to do so.
2.
You are now asked to choose your synchronizing settings.
3.
Note: You must choose a different name for each R380e you connect
to your computer. R380 Communications Suite uses the name you
enter to identify information and backup files specific to each R380e.