Iax Settings; Iax Settings/General; Iax Settings/Registration; Table 48: Iax Settings/General - Grandstream Networks UCM6510 User Manual

The UCM6510 IAX global settings can be accessed via web GUI->PBX->IAX Settings.

IAX SETTINGS/GENERAL

Bind Port
Bind Address
IAX1 Compatibility
No Checksums
Delay Reject
ADSI
Music On Hold Interpret
Music On Hold Suggest
Bandwidth

IAX SETTINGS/REGISTRATION

IAX Registration Options
Min Reg Expire
Max Reg Expire
IAX Thread Count
IAX Max Thread Count
Firmware Version 1.0.0.5

IAX SETTINGS

Table 48: IAX Settings/General

Configure the port number that the IAX2 will be allowed to listen to. The
default setting is 4569.
Configure the address that the IAX2 will be forced to bind to. The default
setting is 0.0.0.0, which means all addresses.
Select to configure IAX1 compatibility. The default setting is "No".
If selected, UDP checksums will be disabled and no checksums will be
calculated/checked on systems supporting this features. The default
setting is "No".
If enabled, the IAX2 will delay the rejection of calls to avoid DOS. The
default setting is "No".
Select to enable ADSI phone compatibility. The default setting is "No".
Specify which Music On Hold class this channel would like to listen to
when being put on hold. This music class is only effective if this channel
has no music class configured and the bridged channel putting the call
on hold has no "Music On Hold Suggest" setting.
Specify which Music On Hold class to suggest to the bridged channel
when putting the call on hold.
Configure the bandwidth for IAX settings. The default setting is "Low".

Table 49: IAX Settings/Registration

Configure the minimum period (in seconds) of registration. The default
setting is 60.
Configure the maximum period (in seconds) of registration. The default
setting is 3600.
Configure the number of IAX helper threads. The default setting is 10.
Configure the maximum number of IAX threads allowed. The default
UCM6510 IP PBX User Manual Page 148 of 192