Table of Contents
Advertisement
Replacing Light Bulbs
The P Series light bulbs can be replaced in a few simple steps. Follow
the directions for removing the door on page 35. Once the door has
successfully been removed, proceed with figures 29 - 29c.
Figure 29. Remove the up-lighting glass from the burner tray.
Figure 29.b Wear gloves when handling light bulbs. To remove a light bulb, pull connecting wire
away from bulb and pull light bulb up. Replace with new light bulb.
Figure 29.c Rotate newly replaced bulbs in a full circle. Place glass cover back in the burner tray.
46
Troubleshooting
The following is a troubleshooting chart of possible problems:
PROBLEM
SOLUTION
Pilot Igniter won't
1. Check the MAIN ON-OFF switch (typically located below the
spark
valve cover) and turn ON
2. Ensure main power is ON or new batteries are installed in the
remote control and backup battery pack (if available).
3. Check the 3.15A fuse in the control box and replace if
necessary
Pilot Igniter
1. Verify the Inlet and Manifold Gas Pressure are within
sparking, but Pilot
acceptable limits
burner will not light
2. Check all connections to gas valve
3. Check connection to stepper motor (if available)
Pilot lights , but
1. Check and verify all wiring connections as per the wiring
Main burner will not
diagram.
Light
2. Verify the inlet and Manifold Pressure are within acceptable
limits
Pilot lights , but
1. Check the Pilot Flame Sensor Rod and clean with steel wool
Main burner will
or similar.
not Light and igniter
2. Check the Pilot hood and clean with steel wool if dirty.
continues to spark
3. Adjust pilot flame using the pilot adjustment screw if the pilot
flame is too long or too short (Flame should fully engulf the
sensor rod and must be stable).
4. Check and make sure the ground wire from the pilot is
connected to the fireplace body.
Fans not working
1. Ensure main power is ON (fireplace may be operating on back
up batteries).
2. Check the 3.15A fuse in the control box and replace if
necessary
One or more light
Contact the local dealer for repairs or service
bulbs are not
working
If your fireplace still does not operate correctly, consult your local
Montigo dealer.
All service and repairs should be performed by a qualified
Technician.
All spare parts, optional fans, and optional trim finishes are available
from your local Montigo dealer.
Appendix
XG0199 - 170223
Hide quick links:
Advertisement
Table of Contents
