Remote Operation (Optional For Pl Units) - Montigo P38 Installation & Maintenance Manual

Remote Operation (Optional for PL Units)

The Proflame 2 System consists of the following elements:
1. Pilot Assembly
2. Proflame Gas Valve.
3. Proflame 2 Control Module
4. Wiring Harness
5. Variable Speed fans (If applicable)
7. Proflame 2 remote control
8. Battery Pack
9 Manual override switch
NOTE: Can not be used with home automation systems.
The Proflame 2 Transmitter controls the following
fireplace functions
(all functions may not be available if used on a PL unit)
1. Main Burner On/Off
2. Main Burner flame modulation (6 levels).
3. Choice of standing or intermittent pilot (CPI/IPI).
4. Thermostat and Smart thermostat functions.
6. Fan speed modulation (6 levels).
The Proflame 2 Transmitter uses a streamlined design with a
simple button layout and informative LCD display. A Mode Key is
provided to index between the features and a Thermostat Key is
used to turn On/Off or index through Thermostat functions, see
Figure 27. Additionally, a Key Lock feature is provided.
WARNING
Do not expose remote control to temperatures below 0°C (32°F) or
above 50°C (122°F)
CAUTION
Property Damage Hazard. Excessive heat can cause property damage.
The appliance can stay lit for many hours. Turn off the appliance if it is
not going to be attended for any length of time.
XG0199 - 170223
:
SW1
SW1 = Programing Button
LED1 = Red Diagnostic Light
LED2 = Amber Programing Remote Control Light
Transmission
Thermostat
On/Off/State
Temperature/Level/State
Flame On
Fans
Operation
Blue back lit LCD display
On/Off key
Thermostat key
Up/Down arrow key
Mode key
Figure 27. Proflame 2 Remote
LED1
LED2
Figure 27.b Proflame 2 Control Module
Key lock
Set Point
Figure 27.c Remote Control LCD Display
Low battery alarm
Room
Temperature
CPI mode
(optional)
Lights On/Off
(P series only)
Not Used
Not Used
41