Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System; Cleaning The Parksense System - Dodge Challenger 2016 Operating Information Manual

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
ParkSense Switch
When the ParkSense system is
disabled, the Drivers Information
Display (DID) will display the
"PARKSENSE OFF" message for
approximately five seconds. Refer
to "Drivers Information Display (DID)" in "Under-
standing Your Instrument Panel" for further in-
formation. When the gear selector is moved to
REVERSE and the system is disabled, the DID
108
will display the "PARKSENSE OFF" message
for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be ON when
ParkSense is disabled or defective. The
ParkSense switch LED will be OFF when the
system is enabled. If the ParkSense switch is
pushed and the system is disabled or requires
service, the ParkSense switch LED will blink
momentarily and then the LED will be ON.
Service The ParkSense Rear Park
Assist System
During vehicle start up, when the ParkSense
Rear Park Assist System has detected a faulted
condition, the instrument cluster will actuate a
single chime, once per ignition cycle and it will
display the "PARKSENSE
WIPE REAR SENSORS" or "PARKSENSE UN-
AVAILABLE SERVICE REQUIRED" message
for five seconds. Refer to "Driver Information
Display (DID)" in "Understanding Your Instru-
ment Panel" for further information.
When the gear selector is moved to REVERSE
and the system has detected a faulted condi-
tion, the Driver Information Display (DID) will
display
WIPE REAR SENSORS" or "PARKSENSE UN-
AVAILABLE SERVICE REQUIRED" message
for as long as the vehicle is in REVERSE. Under
this condition, ParkSense will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" appears in the Driver Information
Display (DID), make sure the outer surface and
the inside of the rear fascia/bumper is clean and
clear of snow, ice, mud, dirt or other obstruction,
and then cycle the ignition. If the message
continues to appear see an authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE RE-
UNAVAILABLE
QUIRED" appears in the DID, see an autho-
rized dealer.

Cleaning The ParkSense System

Clean the ParkSense sensors with water, car
wash soap and a soft cloth. Do not use rough or
hard cloths. Do not scratch or poke the sensors.
Otherwise, you could damage the sensors.
the "PARKSENSE UNAVAILABLE