Login Overview - HP FlexFabric 7900 Series Configuration Manual

Login overview

The first time you access the device, you can log in to the CLI of the device through the console port.
After login, you can change console login parameters, or configure other access methods, including
Telnet, SSH, and SNMP.
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about
FIPS mode, see Security Configuration Guide.
Telnet login is not supported in FIPS mode.
Table 6 Login methods at a glance
Login method
Logging in to the
•
Logging in through the console
port locally
•
Logging in through Telnet
•
Logging in through SSH
Accessing the device through SNMP
Default settings and minimum configuration requirements
CLI:
By default, login through the console port is enabled, no username or
password is required, and the user role network-admin is assigned.
After login, configure password or scheme authentication mode to
improve device security.
By default, Telnet login is disabled.
To Log in through Telnet, complete the following configuration tasks:
•
•
•
•
By default, SSH login is disabled.
To log in through SSH, complete the following configuration tasks:
•
•
•
•
By default, SNMP access is disabled.
To access the device through SNMP, complete the following
configuration tasks:
•
•
Enable the Telnet server function.
Assign an IP address to a Layer 3 interface and make sure the
interface and the Telnet client can reach each other.
Configure an authentication mode for VTY login users. By default,
password authentication is used but no password is configured.
Assign a user role to VTY login users (network-operator by default).
Enable the SSH server function and configure SSH attributes.
Assign an IP address to a Layer 3 interface and make sure the
interface and the SSH client can reach each other.
Configure scheme authentication for VTY login users (password
authentication by default).
Assign a user role to VTY login users (network-operator by default).
Assign an IP address to a Layer 3 interface, and make sure the
interface and the NMS can reach each other.
Configure SNMP basic parameters.
15