Alternate Preparing A Version 2.0 Nortel Networks Wlan - Access Point Or Remote Edge Access Point - Nortel AS-1200-BG-EXT Quick Installation Manual

External-antenna nortel networks wlan

Hide thumbs

Table Of Contents

Table of Contents

blink sequentially back and forth for more than five minutes, the AP is unable to find its Primary

Nortel Networks WLAN - Wireless Security Switch. Check the connection between the AP and

the Nortel Networks WLAN - Wireless Security Switch, and make sure the AP and the Nortel

Networks WLAN - Wireless Security Switch are either on the same subnet or that the AP has a

route back to its Primary Nortel Networks WLAN - Wireless Security Switch. Note that the

Remote Edge Access Points at each remote location must be on the same subnet to allow client

roaming. Also, if the Nortel Networks WLAN - Access Point or Remote Edge Access Point is not

on the same subnet as the Nortel Networks WLAN - Wireless Security Switch, make sure there

is a DHCP server on the same subnet as the Nortel Networks WLAN - Access Point or Remote

Edge Access Point.

After you have prepared all Nortel Networks WLAN - Access Points, reconfigure the Nortel Networks

WLAN - Wireless Security Switch so it is not the Master. A Master Nortel Networks WLAN - Wireless

Security Switch should only be used for configuring Nortel Networks WLAN - Access Points and not in a

working network.

After completing

Step 2: Configuring the Nortel Networks WLAN - Access Point or Remote Edge Access

Point Before Installation

continue with

Step 3: Preparing Mounting

Alternate Preparing a Version 2.0 Nortel Networks WLAN - Access Point or Remote

Edge Access Point

If your Nortel Networks WLAN - Access Point has Operating System 2.0 or a later version (which

includes all Remote Edge Access Points) loaded on it, you may choose to use this procedure. If your AP

has Operating System 1.2 or earlier loaded on it, or if you do not know what version the AP has loaded,

use the

Preparing a Version 1.2 Nortel Networks WLAN - Access Point

Note:

This procedure assumes that you are preparing a version 2.0 Nortel Networks WLAN -

Access Point or Remote Edge Access Point to interoperate with a version 2.0 Nortel Networks

WLAN - Wireless Security Switch. It also assumes that your Nortel Networks WLAN - Wireless

Security Switch is already operating in LWAPP Layer 3 Mode. It also assumes that you are

using the Internet Software Consortium (ISC) DHCP Server V3.0pl1. Finally, it assumes that if

you have deployed multiple Nortel Networks WLAN - Wireless Security Switches, that the

Nortel Networks WLAN - Wireless Security Switch you use to initialize the Nortel Networks

WLAN - Access Point is in an Airespace Mobility Group with the Primary Airespace Switch or

Appliance you want to assign to the new Nortel Networks WLAN - Access Point or Remote

Edge Access Point.

When you are preparing a version 1.2 Nortel Networks WLAN - Access Point to interoperate with a

version 1.2 Nortel Networks WLAN - Wireless Security Switch, use the procedure found in the version

1.2 Nortel Networks WLAN - Access Point Quick Installation Guide.

March 16, 2004